
APCI-8008-STPMotion control board version for stepper motors
The board keeps the architecture of the full version and narrows its use to axes with a stepper motor, for which it generates the command signals from its own processor.
The motion profile is computed onboard: the computer sends the targets and reads the state, while pulse timing stays independent of the load of the operating system.
At a glance
- Memory: RAM 64 MB, Flash 32 MB (1 GB optional)
- Channels: 3
- Acquisition specifications: RS422 step/direction outputs per channel, pulses up to 2 MHz
- Isolation voltage: 1000 V (opto)
- Board function: Motion control
Technical specifications
| Memory | RAM 64 MB, Flash 32 MB (1 GB optional) |
|---|
| Digital I/O | 16× isolated DI (24 V) + 8× isolated DO (24 V, 500 mA) |
|---|---|
| Connectors | D-Sub |
| Channels | 3 |
|---|---|
| Acquisition specifications | RS422 step/direction outputs per channel, pulses up to 2 MHz |
| Isolation | Yes |
| Isolation voltage | 1000 V (opto) |
| Board function | Motion control |
|---|---|
| Architecture standard | PCI |
| Bus interface | PCI 32 bit, 3,3/5 V (spec. 2.2 PCISiG) |
| Dimensions | 175 × 106 |
|---|
| Operating temperature | 0–60 °C |
|---|
Data extracted from the manufacturers' technical sheets: the official product spec sheet remains the reference for final confirmation.
Documentation
In the same family
More products from the same series: select up to 3 and compare them side by side.
In the same category

Let's talk about your project
Phone and email go straight to our technical sales team in Turin: the first answer is already a technical one.









