Scheda ADLINK ETX-Proto con slot PCI, connettori posteriori e componenti a circuito stampato verde

ETX-PROTOETX reference carrier board in ATX format for development and evaluation

Manufacturer

ETX-Proto is the carrier board you use to bring an ETX module onto the bench: 304.8 x 190 mm in ATX format, so it mounts in a standard cabinet and leaves room for probes, cables and the boards under test. It is a development and validation platform, not a plate to integrate in the field.

What sets it apart is the breadth of the exposed I/O: alongside the primary Super I/O there is a Secondary Multi I/O section with COM3 RS-232, COM4 switchable RS-232/422/485, IrDA header, secondary parallel port and up to two floppies. On the video side, VGA on a DB25 connector, dual channel LVDS and PAL/NTSC TV-out coexist; power accepts onboard ATX and AT connectors, with RESET and ATX switch on board.

The supply includes the CF socket assembly and the UDMA HDD, SATA, FDD and TV-out cables.

At a glance

ETX ver 2.7 (3.0) module interface
Four 32-bit PCI slots
Three 16-bit ISA slots
POST codes on 7-segment display
Disk-On-Chip and CF card support

Request information Full specifications ↓

Technical specifications

Video outputs	DB25 connector for analog VGA displays (on rear I/O panel) · Onboard header for PAL/NTSC TVTV-out (NTSC, PAL), LVDS 32-bit

Ethernet ports	RJ-45 (on rear I/O panel)
Serial interfaces	Two 16550 compatible RS-232 ports (COM1/2) · Two additional ports COM3/4 from secondary multi I/O
Digital I/O	F75111R provides 20× GPIO.
Other I/O	1× port SSP, ECP, and EEP mode
Audio	Onboard amplifier with Line-In, Speaker-out and Mic (on rear I/O panel) · Line-In/Out, Speaker-out · Audio amplifier
USB ports	4× ports (on rear I/O panel) v1.1 and v2.0 compatible