A panel to put where the PC does not fit
DM2-W101G-R10 is a 10.1″ industrial monitor with 1280x800 resolution: connect it to the controller you already have and bring the operator interface where it is needed, on the machine or on board a vehicle. There are three video inputs — VGA, DisplayPort and HDMI — so you do not have to choose the source at the specification stage.
Bonded glass, not just resting on it
The touch is 10-point PCAP, with anti-UV and anti-glare surface, and the glass is optical bonded: no air remains between LCD and touch, so no internal condensation and fewer reflections in direct light. Brightness is in the high range (400–599 cd/m²), contrast 800:1, viewing angles 178°/178°, backlight life 20000 h. The touch controller is ILITEK.
What it withstands, and what it does not
- Protection rating: IP65 on the front — this is the front, not the entire enclosure: the rear must be protected by the panel
- Operating and storage temperature: -20 to 60 °C
- Power supply: 9–36 V DC, DC jack or 3-pole terminal block
- Declared consumption: 52.8 W
- Aluminum and metal frame, black and silver, 1.52 kg
- Certifications: CE, FCC
Mounting and operating environment
Mounting is panel or VESA bracket; the panel cutout is 241.80 × 157.80 mm. The OSD is controlled by a 5-key membrane keypad. On the I/O side there are four USB 3.2 Gen1 Type-A (5 V 2 A), one Type-B and an internal USB 3.0 hub, plus a line out output; the 720P wide angle fixed-focus camera and the internal 2 × 2 W speakers are features to be verified on the ordered configuration.
If you need the same front panel on a different diagonal, or a cutout that fits an existing panel, the monitor can be made to measure: the technical department starts from this frame.
